|FanAir News - Info- Blog Posts
We welcome the opportunity to work with you and your specifications to design and build an efficient Air-System component part specific to your requirements.
All FRP Shell Construction, 1/4” to 3/8” Nominal Thickness using “Fire Retardant Vinylester Resin” using hand lay-up and/or chopped strand construction method.
10 Mils of exterior UV Resistant Gel Coat.
Pre-Filter 316SS Mesh Pad Pre-Filter.
Polypropylene Mesh Pad Post-Filter.
Polypropylene Filter Grids.
Flanged Inlet, Drilled with EPDM Gasket.
Flanged Discharge, Drilled with EPDM Gasket.
Filter Access Door with EPDM Gasket and Toggle Clamps.
Dwyer 2000 Series Magnehelic Differential Pressure Gage Mounted .
2” Low-Point Drain Coupling.
Fiberglass Support Legs w/ base Flange.
Filter Cabinet Constructed in accordance with ASRAE Standards.
14 Ga. Stainless Steel Construction.
4 Each, Legs with Hold Downs for Filter Housings.
6 Each, 2” Thick, Aluminum Pre- Filters, Washable – Smith Life-Time Filters
6 Each, 2” Thick Pleated Post Filters, High Capacity Merv 13 Rated Filters, Farr 30-30 or Equal.
1 Each, Hinged Filter Access door w/ 3 Quick Release Latches and Gasket.
1 Each, Dwyer Series 2000 Magnehelic Differential Pressure Gage mounted and piped.
1 Each Collar on back side of cabinet to match blower inlet size and Centerline Dimension.
Above filter assemblies will be will be factory assembled.
Show above are Aluminum Washable 'life long' type permanent Pre-Filters, followed by MERV 6 pleated secondary filters providing enhanced particulate arrestance, resulting in longer service life than the conventional low efficiency panel filter. Typically, 2" pleated type filters will last up to 6 months or longer, depending upon operating conditions, as compared to the typical 1 month life cycle of disposable fiberglass filters. The deeper 4" pleated versions will typically provide even longer life cycles, up to 1 year or more.