3024 E. Chapman Ave. # 218 Orange, CA 92869 USA

|   FRP Inline Filters

Grease Trap Filters and Mist Eliminators

In wet well sewer pumping and lift stations Odors from Hydrogen Sulfide Gas must be treated by means of Fume Scrubbing, Carbon Adsorption or BioFitration Methods. The Airstream may also be contaminated with Grease, Dirt, Sludge and other by products of manufacturing such as Fibers, Lint, Plastic, Paper, Cotton or Polyester Fibers. These materials can prematurely foul the Media Bed of the Fume Scrubbing process. Additionally these materials have the potential to build up on an Odor Control Blower's Impeller causing the Blower wheel to go out of balance by material sticking to the rotor. The FanAir Grease Trap Filters can remove 99% of any airborne materials that are pulled into the Odor Control system.

Fiberglass Grease Filters


Benefits of the FanAir Co. Grease Trap Pre-Filters Include: • They extend the life and service of the Blower and the Odor Control System. • They keep Sludge from Building up on the Blower Wheels / Impellers. • The Filters are cheap and are 'sacrificial' compared to repairing replacing Blower Impellers, Bearings and Shafts. • Abrasion to the FRP Blower Airstream Surface C-Veil is kept to a Minimum, thus extending life of the Blower. • Pre-Filters Prevents Fouling of Scrubber Packing Media, Carbon Media or Biofilter Media.

Inline Filters

 

Inline Grease Trap Pre-Filters for Odor Control Blowers, constructed in Corrosion Resistant Fiberglass Reinforced Plastic, using 1 or 2 layers of Surface C-Veil and Fire Retardant Vinylester Resin and Fiberglass Matt and Roving, typically Spray up construction, with Flanges, Filters, Filter Access Doors, Drain and Support Legs. All Grease Trap Filters are furnished with Differential Pressure Filter Gages, FRP sample port fittings, Stainless Ball Valves, Stainless Tubing and Stainless Hardware.

Mist Eliminators


Fiberglass Mist Eliminators, typically installed at the end of a system to prevent saturated air or moisture or wet chemicals from going to atmosphere.  Furnished either horizontal or vertically mounted with options for single and two stage filtration. Chevron type mist eliminator blades Mesh Pad section are available to remove moisture before or after wet chemical process equipment.

For additional information, please download our Inline Grease Filter and Mist Eliminator brochure.

200 OK

OK

The server encountered an internal error or misconfiguration and was unable to complete your request.

Please contact the server administrator, [no address given] and inform them of the time the error occurred, and anything you might have done that may have caused the error.

More information about this error may be available in the server error log.